If you have a Gigabit LAN a crossover cable will not work all that well.
But what you need to do is setup the computer directly connected to the Modem through the Network Set Up Wizard and tell it that this computer connects directly to the Internet and that other computers connect through this computer. If you wish to share Files & Printers you need to enable this option and at the same time take a note of the name of the Workgroup that you are using. When you finish the Network Setup Wizard just click on End and allow it to shut down.
Then go to the other computer and run the Network Setup Wizard on that make sure to use the same Workgroup name and if you want to share files & printers enable Share Files & Printers then tell that computer that it connects to the Internet through another computer on the Network or a Residential Gateway and allow it to finish the setup. Again chose the Finish option and do not make a Floppy Disc as it's unnecessary.
You can now access the Internet through the Crossover cable on the second computer though you may be asked to reboot each system and if you want to share anything now is the time to setup the shares by selecting what you want to share right click on it and then chose the Share Option.
With Printers you not only need to share the Printer on the computer that it's connected to but you'll need to install the software on the other computer and then on the setup tell the installer that you are using a Network Printer and Browse the Network to find the printer and then when that is located and clicked on continue with the software setup.
Col