Question Locked

Need Help wiht my hardrive

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
My hardrive doesn't work. It is recognized by the motherboard but not by the os. It is listed in the bios. The harddrive crashed one day and it didn't load windows. SO i bought a new harddrive and motherboard put windows on it and put the old harddrive as slave. It wasn't recognized by the os.

6 replies

by hal 9000

If there is no valid partition on the HDD it can not be seen by the OS no matter what OS it is that you have installed.

Depending on the OS that you have installed you need to format the HDD and this varies between the different OS's available so if you would care to post back with the OS that you are using maybe then someone can help you with how you should format the drive.

Col

by kpak44wh

it might need to be formatted, but usually windows xp will
ask if you to format it. I would get the manufactor's disk
tool image cd for it, boot from that cd, and it should have a
utility program that partition and put the driver on it so
windows will see it. Some of the newer drives are like that.

by buffus007

Check the jumpers on the back of your old hd - chances are that it is in the "Master" position. Now that you've installed it as a slave the puter won't see it unless the jumper is in the right ("Slave") position.
Also be sure your cables are correct for the master/slave config. With the proper jumper settings you should see the drive in windows explorer - regardless of os.

by olio botnet

1)New hard drive installed....check
a)was able to install windows on it so that means there was an formatted drive with a good partition table on it....correct? If not do what others have said and format drive.
b)Which Windows did you put on it? For many pieces of hardware there still is no drivers shipping for Vista on the manufacturers driver disc supplied with the hardware and you may have to go to manufacturers web site to download for your specific hdd. If not the problem see next step.
2} All things taken consideration when you installed did you get a successful boot? Logged into windows and all with no error codes? If you think you did then it's possibly a driver issue. If you didn't get a successful boot then it may be a misconfigured jumper setting.

by daveo2000

Here is what I understand:
* Old system state (no longer functional)
- 1 hard drive that failed one day.

* 2nd system state (functional)
- 1 new hard drive with (some version of) Windows on it

* 3rd system state (partially functional)
- 2 hard drives (new one with OS; old one as slave)
- At boot you see both drives but at run time you don't see the old drive as a drive letter.

Is this correct?

Jumper settings -
[b]Is the new drive set as MASTER or CABLE SELECT?[/b] You said that the old one is set as SLAVE but if the new one is set as CABLE SELECT and not MASTER you could have a problem.

Channel -
[b]Have you tried the drive on the other channel?[/b] Get another cable and put the drive on the secondary IDE channel and see what happens.

Format -
[b]Is the drive still formatted?[/b] I am less likely to think it is this one since you said you installed it as SLAVE after it had already been your OS drive.

That should keep you busy for at least a 1/2 hour while I go get breakfast. ;)

This discussion is closed to new replies.