Question Locked
0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Bought a Netgear WGPS606 wireless print server so I could print from laptop without having to turn my desktop on. Desktop OS is Win2K, I have a wireless Verison DSL modem, an HP all-in-one 7310. Could not figure out how to connect the ethernet plug from the router to the desktop as I already have the DSL modem plugged in there. Can you connect the print server directly to the wireless modem? I tried that and got an IP address conflict that I cannot resolve. Did I buy the wrong wireless print server? or is there a better correction for my problem?
2 replies
by tripmeup1 Accepted solution
Clarifications
by Former member Accepted solution
To take off all of your computers from the modem router. Now attach the Netgear WGPS606 to your modem router and power up then attach your laptop to your new Netgear and see if you can access the Internet. If all is ok then attach your other computers (one by one) and see if you get any errors. When all done, the best way now is to update the firmware on the Netgear WGPS606 itself. this will cure some of the problems that you are having.. Hope this helps you.
Please post back if you have anymore problems or questions.
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending
Question Unanswered
How Can IT Teams Detect Hardware Bottlenecks in Business Networks?
0 helpful
0 replies
Question Locked
Using multi-NIC setup for NAS + router — better than VLAN?
0 helpful
4 replies
0 helpful
5 replies
Question Locked
Unknown device connected to my network
0 helpful
2 replies
Question Locked
How to change public IP without ISP?
0 helpful
2 replies