Hi my friends I got an email from an expert and he gave me the solution that make my router work perfectly again. Please read below. Thanks for all your help.
Dear Ricardo,
I understand that you are unable to go online. This is because the modem is not in bridge mode.
Please try these following steps :
Disconnect the DSL Modem from the Router.
Please reset your router by holding down the reset button for 60 seconds with a paper clip, which you could find next to the antenna on the router. Look at the diagram provided on the bottom of the router to locate this button. Now power off & power back the router. Connect the router to the computer through one of the ports.
Unplug the power cable of the router for 10secs and then plug it back.
Login to the router configuration page using http://192.168.1.1 (or) http://www.routerlogin.com/basicsetting.htm
By default, the username is admin, the password is password.
1. Goto LAN IP SETUP.
2. Change the IP address to 192.168.10.1 and starting IP address as 192.168.10.2 and Ending IP address as 192.168.10.51.
3. Apply the Changes.
4. Unplug the power cable of the router.
5. Connect your DSL Modem Back to the Internet port of the router.
6. Login to the router configuration page using http://192.168.10.1/start.htm
By default, the username is admin, the password is password.
Click on Setup wizard - it will detect the type of internet connection you have - enter your ISP parameters and save the settings .
1. Dynamic ip - click next and Save the settings. (If you have a Cable Connection)
or
2. PPPOE detected - click next and type in your ISP user name and password.(if you have a DSL Connection)
or
3. Static ip detected - click next and type in the ip address provided by your isp and save the settings
Enter your ISP parameters (any one as detected and save the settings as mentioned above ).
You will be able to go online after the settings are saved.
Click Wireless Settings under Setup.
Change the SSID from NETGEAR to any other name.
Select the appropriate region.
Change the channel to 6.
Select the security as disable and apply the settings.
You will be able to go online both wired and wirelessly after the settings are saved by clicking on APPLY.