Question Locked
0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a Netgear DG834G network which works fine on wireless & cable. However in one room the wireless has a poor or non existent signal so I have installed a Linksys Powerline AV Ethernet Adapter. Whichever computer I try to get on the network with (all are running on Windows XP professional) using the adapter on either wireless or cable finds the network but the network will not allocate an IP address to allow connection to the internet. Any ideas?
3 replies
by lentay Accepted solution
Clarifications
by normh3 Accepted solution
I am not familiar with this product but it is possible that you have some suspect connections in the AC wiring in your building. Just for grins, I would configure a static IP address on your computer and see if you get proper connectivity.
by robo_dev Accepted solution
Many wireless/powerline adaptors do not play well with DHCP, so if you assign a static address, it will work.
There have been some forum discussions that the powerline adaptors sometimes take as long as two minutes to get a DHCP lease.
I would repeatedly try the 'ipconfig /release all' and 'ipconfig /renew' commands over and over for three minutes to confirm this.
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending
Question Unanswered
How Can IT Teams Detect Hardware Bottlenecks in Business Networks?
0 helpful
0 replies
Question Locked
Using multi-NIC setup for NAS + router — better than VLAN?
0 helpful
4 replies
0 helpful
5 replies
Question Locked
Unknown device connected to my network
0 helpful
2 replies
Question Locked
How to change public IP without ISP?
0 helpful
2 replies