Discussion Locked

Network Routing

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am trying to setup a 2600 series router that is only using two FE ports. I am trying to route from one network to another. The network is 10.10.155.0(f0/0) and the other is 21.21.21.0(f1/0). The 21.0 is going to a firewall that is using VPN tunnel and the 155.0 network is going to a router on a similar subnet. I am not using the DSU/CSU card on this router only the Ethernet and an ethernet module. How do I get traffic to route over the 21.0 network?

1 reply

by synner

Your networks are attached to the same router. Just set the default gateway on the workstations and you should be able to get the two networks to talk to each other.

This discussion is closed to new replies.