Question Locked

New Dell SCSI HDD not visable in Windows Server 2003

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Afternoon,

Just recently installed a new 300GB SCSI HDD into a Poweredge 2650. Unfortunately I am unable to view it in Windows and therefore cannot format or partition it etc. This isnt to be used for RAID but to be used simply for extra space. Have tried installing the Openmanager storage manager software but getting a message that no storage containers found?

Appreciate any feedback,

Thanks

Steve

6 replies

by ic-it

How is this one connected? Is it through the SATA Raid Controller or on the SATA header on the MB?
My 830 had the on board SATA disabled in setup (F2).

by info

Thanks for the reply, its connected through the SATA RAID controller as an additional HDD so needs to be configured away from RAID 5 as its only purpose if for more disk space. It is showing in Windows as a SCSI drive but of course wont let me partition or format? tried installing management tools but it cannot seem to locate it?

by Former member

You will have to mount the drive so that you can have access. When you right click on the drive, a menu comes up, is there the word "mount"?. If so then click on it.

Please post back if you have any more problems or questions.

by ic-it

during POST. You will see a prompt to press a ctrl something (A?) to enter the RAID controller's setup screen. You configure it there.

by info

Thanks for your post, unfortunately I am unable to view the drive in Windows so not possible to right click it?

This discussion is closed to new replies.