Question Locked

New installed RAM is not recognized by BIOS

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I installed new 1GB RAM instead of my 256 and BIOS recognized only 512MB. When i plug off my Video card (NVidia GeForce 6500) and reboot the system, BIOS does recognized 1GB.
Motherboard is ASUSTek P5RD1-VM
RAM - DDR 400Mhz
Any suggestions?

2 replies

by oh smeg

The confusing bit is about when you add the Video Card getting all of the Installed RAM Shown.

Though as ASUS only recommend 2 1 Gig Ram Makers and Model it very well could be incompatible RAM for that M'Board. If you look in the M'Board Manual on Page 1-16 there is a List of Compatible RAM provided and ASUS say that the

NANYA NT1GD6458HADF-6K

and

HANYA NTSDS64M8AF-6K

ARE the only suitable RAM for this M'Board in the 1 GIG capacity. But as this M'Board uses Dual Chanel RAM to get the best performance you should be using 2 Sticks of Identical RAM in either the Blue or Black Sockets. This will allow the RAM to feed the CPU at 100% of the CPU Capacity instead of 50% while in Single Chanel Mode. With these M'Boards if you insert a third stick of RAM when you have already fitted 2 Identical Sticks the M'Board switches back to Single Chanel Mode but if you insert another Identical Pair in the Other RAM Sockets the M'Board remains in Dual Chanel Mode.

If you have a 512 MEG Video Card I suppose that BIOS is showing the Complete RAM Fitted to the System but I'm not sure just how plausible this is.

However if you have High Density RAM Fitted to a M'Board that can not Map it and can only map Low Density RAM you would see exactly 50% of the RAM that you installed as the M'Board [b]Can Not[/b] correctly Map the RAM. To check this out all you need do is look at the new RAM it should have Chips on both sides of the Fiberglass Circuit Board. If it only has Chips soldered on one side it is High Density RAM and this M'Board according tot he Users Manual at least should only use Low Density RAM.

Col

This discussion is closed to new replies.