Question Locked

new processor and computer wont boot

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have an old Gigabyte GA-7X (rev.1.01) Motherboard with an 800 mhz AMD Duron 200 fsb. I recently bought an AMD Athlon 2100+ (palomino) 266 fsb. After installing the new (used) processor the comp. wouldn't boot. I thought well maybee my BIOS is to old so I installed the old processor again, and it still wouldn't boot. The computer starts up, but doesn't boot, the monitor stays in standby. And yes I did change the fsb via the motherboard. And the option of a cmos jumper was not added to this motherboard. Please help.

5 replies

by bcpgm

The MB model does not seem complete.
I did not find such model in Gigabyte website.
Please post again with the complete model name.

There must be jumper setting on the MB.
You may take out the CMOS battery as the last resort. Make sure to unplug the power cord before you do this.

by cg it

a search for the GA-7X motherboard produced no results.

I would venture to say that the BIOS doesn't support the Athlon 2100. You'll have to upgrade the BIOS. If you didn't change the FSB speed to 200 [100X2] when you put in the Duron, that probably is why the comp won't startup.

Clear the CMOS table via the jumper on the mainboard [or take the battery out, then put it back in]. Install the old processor, try booting up to the BIOS.

by ozi eagle

Hi,

My gut feeling, when Iread your post, is that I would be surprised if your motherboard can take the new cpu. A big jump from 800MHz to 2100.

Did you check whether the mobo was suitable for the new cpu?

I suspect that the new cpu did some damage to the mobo (and possibly to itself) when you plugged it in.

Herb

by lcwaipa

The new one will not boot. I looked a little deeper into Gigabytes website and found that the motherboard I was looking at was the wrong one. That's pretty bad since the bios I istalled was also wrong. The board is a GA-7x rev.1 and is listed under other boards. I have a bios for a GA-7xE rev. 1. And now I can't get the correct bios to install. It just tells me that it is an invalid system disk.

This discussion is closed to new replies.