Question Locked

No power to CDROM when HDD plugged in

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi guys,
If no HDD is plugged in both CDROMs get power to them and spin up, but if there is a HDD plugged in the CDROMs get nothing. I have tried it with just one of each but to no avail.

Booting from HDD, it says 'Disk boot failure, insert system disk' which obviously I can't.

Everything in the BIOS is set properly, as are all the relevant jumpers.

Is there something obvious I'm missing or is it a power supply issue, bearing in mind they (2xHDD and 2xCDROM) were working before?

It's a relatively old machine but it runs XP well enough, usually.

Cheers

7 replies

by skdtech

I would bet that your Power Supply is on its way to the retirement home.Consider going out and purchasing a new PSU as soon as possible, preferably one that is rated higher than your present one. If your machine did not originally come with 2xCDROM and 2xHDD then you may have been running near the threshold after the last addition and now the aging PSU can no longer support as much of a draw.

by balge

hi
off chance, does the PC boot off the HDD at all? I mean in either of the IDE headers
Is the HDD tested?
PSU usually gives weird effects when failing
cheers

by xfilz_1133

If the PSU was that bad off the cdroms would not spin up. Sounds like the HDD is on its way out or gone. Is either or both of these drives Western Digital by any chance?

by skdtech

And as both an electronics technician and a PC technician I would say that the PSU is suspect.

This discussion is closed to new replies.