Question Locked

Noise Reducing Server Rack Taller than 25U?

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

My company manufacturers a line of server racks that reduce noise, but the tallest we have is 25U.

We receive an occasional inquiry for a noise reducing rack taller than 25U (usually full height of 42U or 45U), but we are not sure how much interest there would be.

Does your company or any companies you know put more than 25U of equipment close enough to people (employees, customers, patients, etc.) to where a 42U or 45U rack that reduces noise would be needed?

Thanks,

Ken

7 replies

by ---tk---

75%-85% of our racks are 42u high... I have yet to see any higher than that. The rest of the racks are 25u... None of them are noise reducing.

by robo_dev

With servers and switches getting smaller and smaller, it's unusual to need a tall rack on the edge of the network.

Why not make your 25U racks stackable or modular such that you could bolt another 20U on top of the smaller 25U rack?

(You can send me the royalty check later)

by robo_dev

or Gold.

My other brilliant idea is that the rack side panels should be usable as rack shelves....

Right now I have like six unused full-size server cabinets, but I gotta go BUY rack shelves.

If they made the side/top/bottom panels interchangeable, then I could cannibalize old racks for shelves.

by ken

Interesting if nothing else, server rack side panel used as rackmount shelf, I am not sure. Is there a big need to cannibalize old server racks? I would have thought more people scale up instead of down, tell me your thoughts?

Thanks

by robo_dev

So if the rack top panel, side panels, and shelves were all the same metal stamping, this would reduce the parts count.

Plus old racks could be cannibalized for rack shelves. Similarly, if you gang racks together, you get four or six extra rack shelves from the (former) side panels.

Maybe a crazy idea, but.....

I only say this because I have a storage unit of various used server racks that are for sale.

One rack has a front door, but no back door (not interchangeable), and one rack has sides that will not fit any other rack....plus every rack buyer has asked to buy shelves.

If the rack rails are a standard 19" width, why not make the side panel mounts standard? Make the side panels the same stamping as the shelves, make the top the same stamping as a rack shelf, and make front/rear door mounts all standard.

This discussion is closed to new replies.