5 replies
by ron larson
I have had this problem with win98Se and I have have to reformat the hard drive 2 times once in dos & once in windows I also found that some drives require the jumpers to be set differently then the usual slave -master configuration. it's easy to set them wrong. try reseting the jumpers and reformating the drive. I have also found damaged drives drivers and reinstalled them. check your Device Manager for wrong or corrupted drivers. One last thing is that you could have a virus on the drive. I found norton disk doctor to fix these problem pretty good. good luck
Ron
by nyte
Is the slave disk partitioned? It will not be displayed in windows unless there is at least one partition on it. You can check this by running the FDISK command from the command prompt. Be careful not to trash your existing partition.. :)
Cheers
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending