Discussion Locked

Not seeing my slave disk in WIN98SE

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Both master and slave disks displays in the BIOS. But when Windows is loaded there is only the master present and no slave disk.

5 replies

by ð

Is the slave drive a new drive? if it is, you'll need to partition it first before 98 will see it. Goto command prompt and type "FDISK" change to the second(slave) disk and create the partition. Reboot the PC the drive should appear, right click on the drive and format it.

hope that helps

by tomsal

Its certainly true that you need to make sure all drives are correctly partitioned and formated prior to doing anything with them, including storing data on them or even just using them as secondary drives in your preferred OS.

However it is possible that your computers BIOS will read that both drives exist, only to find that in Windows 98SE they don't.

This can be from incorrect jumpers. I've found that different brands of HDs seem to be affected by this differently.

For example, I recently needed to slave an old model Western Digital to a newer WD. I mistakenly kept the primary as the default for single drive at first. BIOS only detected single drive. Shut down, switched it to master - but I again FORGOT to set the jumper for the slave. Well what happened was BIOS now SAW both Drives, but like your dilema they both didn't detect in Windows 98.

Finally (hey it was a bad day - I only forget the simple things, because I'm trying so hard to remember the complex things. ;) ) I set the slave jumper on the slave drive.

Re-booted.. All was right with the world.

So check your jumpers...master set for master, slave set for slave.

NEXT, make sure the cables are firmly connected. If the ribbon cable looks shoddy, replace it without hesitation. Ribbon cables are a dime a dozen.

Keep in mind that BIOS detection and Windows detection don't use the same methods. That's why BIOS detection doesn't always guarantee (though it should be at least a 90-95% sure thing) itwill work in the OS.

BIOS uses hardware detection (CMOS). Windows uses software layers to detect your devices, ala drivers (HAL).

Hope some of this helps, or at least promotes your troubleshooting mindset.

later.

-Tom

This discussion is closed to new replies.