Question Locked

NT4 Backup Controller

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello,

This is my 3rd post people!!! Can someone please tell me why I can not access my servers on the network from my pc or any pc on the network when I shut down my PDC and leaving the BDC on.... The BDC is located at a different segment.

I am trying to test for a disaster recovery plan. If my PDC burns up, the BDC should be able to authenticate all users and they should have access to all other servers as usual... correct?

Do I have to copy all settings off the PDC to the BDC e.g. DHCP, WINS, DNS??

Appreciate the help!~

4 replies

by pser

Yeah. If your PDC is running DHCP, WINS, and DNS ... then this explains why you cannot connect to the BDC when the PDC is down.

I'd look at getting those services OFF of the PDC.

Luck to ya ...

by cyberthugz

Why would I remove those services off the PDC when its running rgt now?? I need the BDC to take over in case the PDC crashes/burns. I think the WINS and DHCP services would have to be configured on the BDC in order for the BDC to work in place of the PDC without promoting the BDC.

by pser

Right now you have a single point of failure. And THAT is why you can not communicate with the BDC when the PDC is down. Those services can be set up on your BDC as fail over or secondary sources for each of those services, and at the least I would do that. However, putting all of your eggs in one basket can be a bad thing. Especially if you are using WS class machines as Domain controllers.

Just my humble opinion.

This discussion is closed to new replies.