7 replies
by gadgetmd
Poster rated this answer.
by cptomlly
Is the drive being detected and set up by the BIOS? If so, right-click My Computer and select Manage. In the Computer Management console, right-click disk management and select rescan disks. After the rescan completes, check the lower-right pane to see if your disk is shown. It will probably be as disk 1, with your primary 120 gig as disk 0. You will then need to right-click on disk 1 (or however it names the 40 gig drive), and select Import Foreign Disk.
If however, the drive does not show up in the BIOS settings, you do not have it installed properly. Check your master/slave settings on the drives.
Hope this helps.
by gadgetmd
Poster rated this answer.
by thechas
Double check the drive jumpers.
The master MUST be jumpered as Master With Slave Present.
(On Western Digital drives, this IS different than the single drive setting.)
The slave drive MUST be jumpered as slave.
Make sure that you are NOT using a cable select style IDE cable.
These typically have a hole punched in the wires between the 2 drive connectors.
If you are using a cable select cable, set both drives to cable select, and make sure that the connections are correct for master and slave.
Make sure that the BIOS is set to auto-detect the all IDE drives. Many times, to speed up the boot process, unused drives are set to none.
I have seen numerous times where different brand drives do not work well together as master and slave.
You can temporarily connect the Quantum as the master or slave drive on the secondary IDE channel in place of, or along with your CD drive.
Chas
by gadgetmd
Poster rated this answer.
by gadgetmd
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending