3 replies
by sgnanakkan Accepted solution
by hal 9000 Accepted solution
Then wait a few minutes to allow the capacitors to discharge and then remove the BIOS Battery. That should clear the BIOS and require everything to be returned to the default factory settings. Then fit a new battery.
If the unit is going to work when you apply power you will get an error message telling you that there is an error with the installed RAM so enter the BIOS and set the Date & Time then exit saving any changes that you have made.
If you still do not get a picture when you do this the unit is unlikely to be working and you may need to start replacing things depending on how much you are willing to spend on this unit. But if there are no LED Light or no fans running it could just be a bad Power Supply which may cure the problem but it could just as easily be a dead M'Board or the wrong RAM fitted.
Did you at least see this running before you bought it?
Col
by johnsnow Accepted solution
Edited by moderator
Message was edited by: beth.blakely@...
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending