12 replies
by darrenm
by donmars
by darrenm
by thechas
Many new motherboards have a LED connected to the 5 volt standby power line.
This LED is to let you know that there is power to the motherboard, and that it is NOT safe to remove or install hardware.
The front panel power switch for an ATX system is just a momentary push button that signals the power control circuitry on the motherboard to tell the power supply to turn on.
Check your CMOS clear jumper. Many motherboards ship with this jumper set to clear. You need to move it to the "normal" position in order to power up.
I have had a number of systems where I had to clear everything to get that first boot.
Remove the CMOS battery, and unplug power for at least 1/2 hour.
Power up, and set your BIOS settings.
Then, install theCMOS battery before shutting down.
For many socket A motherboards, I have found that I need to set the CPU speed manually to correct cold start problems.
Chas
by darrenm
by gkheart1
Hi,
The asus mainboard you are referring to does have the 4 pin power connector on the board. It is located at the top of the board about in the center next to the system memory bank closest to the cpu socket. without the 4 pin connected it will not run. Not all 478 pin P4 boards have this connector. If your power supply doesn't have a 4 pin power connector you will have to get a p4 ps that does. Or, Your ps may have gone sour.
Regards Gil
by darrenm
by darrenm
by darrenm
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending