Question Locked

pc

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
my cpu fan is not rotating what is problem

4 replies

by older mycroft

So now that you know it's not rotating, do not be tempted to keep powering up to 'see if it is working'.

It really matters which fan you are talking about, although they are all necessary components the failure of each one will result in differing levels of damage to your hardware/components.

So, which fan is it?

by oh smeg

A Bearing has failed and the Fan needs to be replaced.

If it is the CPU Fan you shouldn't run the system at all because it will overheat and can damage the CPU and associated components.

If the fan turns freely when you turn it by hand then the most likely thing is that a wire has broken somewhere and the fan is no longer getting power or a Plug may have pulled off resulting in the same thing. Worst case scenario is that the Enameled Covered windings of the Fan's motor have broken down and created a Short Circuit. If the last has happened it will cause a voltage over load through the whatever it connects to doing more damage. So if this plugs directly into a Power Supply lead it will overtax the PS and damage it and if it plugs into the M'Board you will be passing more current through this causing Heat problems and may even cause a Copper Track to vaporise or 1 or several Solder joints to fail rendering the M'Board useless.

Get a replacement fan before trying to restart the computer and fit it. Depending on the type that it is you may be required to use some thermal paste between the Heatsink and CPU or if you can replace the fan without the Heatsink all that is required is to remove the old fit the new and your ready to go.

Of course if there is no power at all getting to the M'Board the Power Supply is dead and needs replacing first.

Col

by rob miners

The Fan is not spinning on the PSU at the rear of the PC and the PC is not starting up.

If you are talking about the Fan on the back of the PC's Power Supply Unit try this. Turn off the power and remove the Power Cord from the back of the PC's Power Supply Unit (PSU). Also try another power outlet or power board.

Reconnect the leads and turn on the PC. If it is working all is good if not replace the PSU or the powerboard.

The Fan is not spinning on the CPU and the PC is running.

Turn off the power and remove the Power Cord from the back of the PC's Power Supply Unit (PSU). Remove the cover from the PC.

Ground yourself by placing the back of your hand on the Power Supply Unit and not moving your feet. By not taking this precaution it is possible that you could inadvertantly cause damage to the PC from an electrostatic discharge.

Disconnect the power lead from the CPU Fan and reconnect it. See if it spins by reconnecting the power leads and starting the PC. If it spins up all is good if not replace the Fan or test it in another PC. If it works in another PC you will have to get an adapter to run the Fan with as the power socket on the board has malfunctioned. If that is the case it might be time to start planning for a replacement board (OEM) or an upgrade if you have a Retail licence. Another test is to spin the Fan if it spins freely it should be OK if not it needs to be replaced.

Regular maintenance

I would give the inside of the case a blowout with compressed air that should be available from an electronics store. When blowing air through the fans make sure that you physically stop them from spinning, as they may generate power and blow something up. Then remove the Heatsink, giving it a thorough clean and reseat the CPU applying new CPU grease.

Keep us informed as to your progress if you require further assistance.

If you think that any of the posts that have been made by all TR Members, have solved or contributed to solving the problem, please Mark them as Helpful so that others may benefit from the outcome. ;) :D

This discussion is closed to new replies.