Question Locked

PC LED lit up, Fan working, CD-ROM drive keep loading, No video.

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I had been using my destop for some graphic work recently, nv had any problem turning off or on. But recently i try to turn on my destop and the LED green light did lit up. but the yellow light below the soft reset button keep flashing every 2 to 3 seconds. The CD-rom drive's green light keep flashing as if it's loading something, but there's nothing inside. There was no beep sound at all, but i can hear a bit of loading going on when i first turn on, but that's it. The fan is working though. The monitor's light just keeps blinking without showing anything.

and this actually happened once before not long ago, but it can be switched on just after a while, but now it's been days but it's still not working.

and after awhile, the CD-rom drive's light and the yellow light below the reset button stopped flashing. As if everything's alright, but there's still no video shown on monitor even though monitor light's still flashing.

and btw, the computer's harddisc drive is running out of space. C drive has less 1GB space while E drive has around 20GB space left. Is this the problem? The ram is only 512mb. graphic card is radeon 9600. intel pentium 4. PC was self fixed - not by me.

Hope someone can help,
i'm not a tech pro so do explain more simpler.

Thanks.
~Kaze

8 replies

by thumbsup2

You said you could hear a "bit of loading going on when I first turn on, but that's it". Is this sound that you hear a normal spinning/accessing sound from the HDD (the usual sound it makes when reading), or is it a kind of regular "thud" or "clucky" sound, maybe discribed as "metal to metal" sound? If it's the latter of the two, the hard drive has probably failed, possibly even beyond recovery. However, I've seen CD's go bad and cause the same symptoms.

First, turn it off and disconnect the CDROM data AND power cables, then try booting. Do you get the same results? If you do, then turn it off again, disconnect the HDD data AND power cables too, then try booting. If you see anything at all on the screen, you should see something about No OS found. At this point, turn it off again, reconnect the HDD cables (be very carefull to get the pins lined up correctly) and turn it back on. Do you hear the sound again? Does it boot?

by seanferd

Make sure that the vdeo cable is securely attached between the monitor and port, pushed in all the way and locked down.

If you are willing to open the system case, make sure the video card is properly seated (pushed in all the way).

There is also the possibility that you really don't have enough power to run the video card (maybe the power supply had just enough power before, but now it is failing). Does your computer have onboard video that the Radeon replaced? You could try removing the card and hooking the monitor cable to the onboard video. If that works, the problem could be the card or the power supply unit (PSU).

I'm sure there will be other suggestions. Please post back with any further questions. Good luck!

by willcomp

You likely have a boot failure. The first thing to do is disconnect all devices not needed for a basic boot. Unplug PC. Disconnect signal and power cables from all drives. Remove all cards except video card. Remove all external devices except keyboard -- that includes USB devices.

Plug back in and try a basic boot. If it boots, sequence devices back until you find the problem. If no boot, you have narrowed possibilities. Post back with results and we'll take it from there.

Hard disk failure is not likely since there is no POST information.

by kaisergrey

i think i just accidentally fried my pc. =.="'

i don't know wad HDD cable or wadever. so i just unplug everything. mainly usb and and speaker. then i saw something about the voltage and i think i shift it to a higher voltage.. and the i saw green light flash from inside the pc. i think the whole pc sort of burnt.. but no smell though.

now the whole pc can't start anymore.

great.

think nothing can be done now.

thanks anyway.

i'll have to re-draw my illustrations.

btw, the only attached cables were the power supply, usb, and speaker. no more.

and also the loading sound was just normal loading sound.

~Kaze

by thumbsup2

... if you're lucky, the data on the HDD is still intact. Chances are though, by switching the voltage, the power supply at the very minimum and maybe the motherboard/processor are probably toast. You'll need to take it to a repair shop to see what's left.

BTW, the cables we were speaking of are INSIDE the computer, not outside. But, it's too late now. Take it to a PRO.

by willcomp

If you don't know, ASK!!!

Time for someone who knows what they are doing.

by kaisergrey

ok yea, i don't know anything about that.

but i'll try if the data can be retrieved.

i didnt know there are cables inside..hah.
=.='

Thanks anyway.

~Kaze

This discussion is closed to new replies.