Question Locked

PC - microcontroller wireless connectivity

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

i want my robot to have all data and processing on the PC. robo connects to the pc to take orders for its movements and sends information back(collected through IR-sensors).
i have chosen an 8051 microcontroller for the robot.

what way can i conect the PC and microcontroller wirelessly?

i would prefer min. 8-bit connectivity, and the cost of equipment matters a lot.as data and processing is distributed, speed may be of consideration.

can u suggest some device which can wirelessly TX/RX RS-232/MAX-232 signal?

2 replies

by yakobianlikes69

I recomend using a basic stamp mmicrocontroller and use there R/F kits with it
But for this you will need two microcontrollers it wich comes out to like 300 dollars all thogether
i did this project once i started off with a basic stamp microcontroller then bought an ethernet controller adapter from there website for 50 dolars then i hooked up that ethernet to a wireless ethernet connector i belive it was 100 or 150$
Later on i upgraded the robot with a hawking wireless network camera and a wifi RABBIT MICROCONTROLLER then used my router to host a website call hotspotbot.com or sumthing i dont have the robot anymore but it was a fun project
u can also go to http://www.drrobot.com/
and i belive vex is comin out with sumthing
and there some kits online too
no matter wat u do though its gonna be a very expensive robot

This discussion is closed to new replies.