Question Locked

PC not respondin 'ven after replacin PSU

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
help me troubleshoot my ESYS board coz even after replacin my psu the cpu still doesnt respond.

3 replies

by rob miners

is there any sign of life at all.

A common reason for shutting down and locking up or freezing is the CPU overheating.

Faulty Fans, Dust and Grime build up on the Heatsink restricting air flow. I would give the inside of the case a blowout with compressed air. When blowing air through the fans make sure that you physically stop them from spinning, as they may generate power and blow something up. Remembering to ground yourself by placing the back of your hand on the Power Supply Unit and not moving your feet. By not taking this precaution it is possible that you could inadvertantly cause damage to the PC from an electrostatic discharge. Then remove the Heatsink, giving it a thorough clean and reseat the CPU applying new CPU grease. If the Fans spin freely when you give them a spin they are probably OK. If there is resistance replace them.

Clean the golden edge of each memory stick with a soft rubber/eraser, remembering not to touch the golden edge of the memory stick. Check with one stick at a time, remembering to disconnect the power from the PC.

Also check Capacitors around the CPU for swelling or bulging.

by masungit

hey, saw your question, you really have a problem there, am not really familiar with that kind of board, does it have a power led? when you plug in your power does the led's light on? if so then you should be hearing beeps for possible error in memory, video, HD etc..if there is no light then still there might be a power problem. im not good in troubleshooting but hope this might help

This discussion is closed to new replies.