Question Locked

PC won't boot to Windows XP after HDD partitioning

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello guru's
I used Partition Magic to partition 30G of a 120G HDD for use as a "data" drive. There was 50G free space on the drive. Once I rebooted as Partition Magic requested to complete the partioning, the system no longer recognised "C" drive and kept rebooting. Safe mode doesn't work either. PM's support site shows the error (46) to be "problems locating a particular sector on the drive."
Could anybody please help - I at least need to recover (copy) files from the drive.
Cheers,
Eric from Australia

6 replies

by computercookie

the first thing I'd try is system restore!

If you can't do this, can you you boot to the command prompt and try system restore from there.

If that fails can you attach the drive to an other PC as a slave drive or in a caddy. (Note you may have ownership issues to overcome before you can access the data.)

If that fails I'd suggest an in-place installation.

Any queries please post back.

Jeff

by david.wallis

I had the same probs with PM, i ended up formating my drive, and never used their software again :)

by elawson

I slaved the HDD on another PC and checked that all of my files were still there - no problems. I then fixed the master boot record using the recovery console (now back in the original PC). When it booted, I stopped the Partition Magic batch file from running and was able to run XP normally.

Thanks again!

by the scummy one

when dealing with HDD changes, partition changes, etc.. ALWAYS back up data first.

This discussion is closed to new replies.