Question Locked

PCI Scanner problem

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi,

My PC has just had a midlife crisis and completely packed up. I managed to get it up and running by stripping out all the cards, flashing the bios, formatting the drive and reinstalling the OS.
In the end I worked out that it was a innoVISION DM1007 EIO IEEE1394 + USB2 combo card that was causing all sorts of trouble.
Now when I boot up I get a message saying...
PCI Scanner - unable to start driver.
So I click ok and get...
PCI Scanner - unable to stop driver.
(or words to that effect)
Once I have clicked ok to that the computer seems to run fine.
Does anyone have any advise?
I am running...
Gigabyte GA-965P-DS3 rev1
Intel Core2 660@2.4GHz
3GB RAM
Radeon x600
Creative Audigy 2 ZS (WDM)
Belkin FireWire 800 3 port PCI card
Windows XP SP3
Many thanks

6 replies

by oh smeg

PCI configuration addresses.

You can generally get away with setting these to Auto with Gigabyte M'Boards but there could be some hardware in use here that requires the individual PCI Slots to have specific Addresses hard set in BIOS. If that isn't the case here the PCI Addressing is just set wrong and needs to be returned to the default configuration.

Col

by thechas

I might be wrong here, but I suspect that Windows is trying to load the driver for the Vision card even though it is no longer connected.

Start by looking in add/remove programs and remove any software listed that was related to the old card.

If you have hardware that connects via the 1394 (fire-wire) port, you may need to reconfigure it to use the new Belkin card.

If the above does not fix things, you may need to manually remove the references to the Vision card in the registry.

CAUTION: Improper use of regedit can disable your system.
It is best practice to back up the registry before editing.

Start by looking for the ENUM sub-key that has the Vision card listed.
Delete all of the Vision sub-keys under the enum branches of the registry.

Close regedit and restart the computer.
If the driver did not stick any keys or calls in inappropriate places, all should work now.

If you still get the error, you may need to dig deeper for keys and even legacy calls for the Vision driver.

Chas

by me

Just uninstalling the Ali driver that came with the vision card seems to do the trick.
Last time I buy cheap components!

by oh smeg

Anyone would remove the Hardware and leave the Driver/Software on the system.

Whenever you remove any Hardware you should always remove it's associated software.

Col

by thechas

Glad to have been of assistance.

It is good manners in this forum to award a thumbs up to a helpful answer.

Chas

This discussion is closed to new replies.