Discussion Locked

Pcmcia-card works only in upper slot

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Recently I reconfigured my (old) laptop. It is a HP OmniBook 2000cs. I reinstalled Win98SE on it because the harddrive is only 1.3 Gb. W2K pro takes more than 2/3 of the free space. Besides I would like to keep the laptop as basic as possible.

I have two pc cards I want to use with the laptop: a fast ethernetcard, which is working fine in either one of the slots. The second one is an USB 2.0 card, and this is where I have a problem. The card is supposed to be in the upper slot, because otherwise it blocks the other slot (the card is twice as thick on the outside). With W2K it worked fine, since I downgraded to Win 98 the software doesn't recognize the card when in the upper slot. In the lower slot it works ok.

So the card is working, the slots are working (NIC works in both of them), the laptop recognizes cards in both slots, but the card application in Win98 thinks that the upper slot is empty when I insert the USB 2.0 card.

3 replies

by dpalsen

Little known fact: Not all PCMCIA slots are created alike. The card you're trying to use may be PC-Card 3.0 compliant, and in many laptops, only one of the slots supports that form factor.

by koelega41

The problem isn't in the hardware, since both slots work normally under W2Kpro, with either one of the cards. Under W98 the Ethernetcard is working properly in both slots, but the USB-card doesn't function in the upper slot. Both slots are similar.

by john hoover

Win98 did not nativly support USB 2.0 if I remember correctly. With the older Omnibook 2000 series, the 98 drivers also may not recognize 32bit Cardbus cards (which I assume a USB 2.0 card would be), but rather only PCMCIA Type 1 or 2. Win2K howeverhad more support for both the newer types of PCMCIA interfaces, and for the newer USB standards. Unfortunately, there may not be drivers to enable these features in Win98. You may consider trying to find a used 4GB 2.5 inch hard drive to upgrade the1.3 gig that is in the laptop now. It's still not a ton of space, but you'll have a little more elbow room, even with Windows 2000 installed.

This discussion is closed to new replies.