Discussion Locked

Peer to Peer Conection

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi, i have one computer with two ethernet cards, under Win 95, and I would connect two computers with a crossover cable to that computer, one under win 95 and the other in win 98, the network doesn?t have internet connection by the moments.
I did the connections but they don?t see each other. What I have to do?

5 replies

by jschein

1. enable sharing on both pc's... Share a folder...

2. Ensure they have microsoft network as their client in network neighborhood (right-click / properties).

3. Put them both in the same workgroup - Any name you make up as long as they are the same.

4. Assign I.P. addresses for both pc's...

pc 1. 10.189.0.1
pc 2. 10.189.0.2

Subnet mask: 255.255.255.0

Gateway... can leave blank unless you have a router with dsl/cable.. If you do, just put that ip in there.

That's it.. Reboot both pc's and voila'

Good luck

by jorgelopez02

But what should I do with the other one that is working like a server for the other two computer, I tried what yo explained to me, nut I didn?t work,
thank you

by bg_27

You have to set each computers ip statically. So you go to the network properties and then TCP/IP settings and change the ip for PC 1 to: 192.168.1.1 and change the IP for pc 2 to: 192.168.1.2. The subnet can be: 255.0.0.0

by jschein

ok, please dont reject answers, it gets people mad when the answers are correct...

1 pc with 2 nics...
DO YOU HAVE DSL OR CABLE? or do you have just 2 nics?

follow my above instructions.

For the pc that has 2 nic.... thenic that has the crossover cable, you need that I.P. address. That will be the Default GATEWAY for the other pc.

For the other pc connecting... Find out the i.p. address of that dual nic system and add 1 #.
For example if the dual nic i.p. is 192.168.0.1, put 192.168.0.2 in the single nic i.p. address. Put in the same subnet mask (either 255.255.255.0 or 255.0.0.0)

That is it

by supern0t

If you followed the above instructions you should be communication useing TCP/IP you can verify this by pinging each WS from the other. But just in case, here is a full rundown of win9x peer to peer config.

Open Network properties
-Under the Identification tab:
Make sure both machines are running on the same Workgroup name.

-Under the Configuration tab:
Verify that the following components are installed. If not install them.
Client for MS Networks
MS Family logon
Your Network Interface Card
NetBUEI -> Net Card
Bindings should be to all MS services
TCP/IP -> Net Card
Ensure each machine has a unique IP address specified ie: 192.168.0.x
Subnet mask should be 255.255.255.0
Bindings should be to all MS services
File and Printer Sharing for MS Networks

Remove IPX if it is still there.

Try that and tell me how it goes.

This discussion is closed to new replies.