Discussion Locked
0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Where do you place the pix 501 between the cable modem and the linksys router or after the cable modem and linksys router?
2 replies
by robo_dev
Since the Pix is a firewall/router and the Linksys is a firewall/router, the best configuration is to use only one firewall/router.
Hooking one firewall/router downstream from the other one can be done, but it takes a lot of reconfiguration (DHCP, DNS, NAT, Firewall configuration, etc). With these two devices you're really doing lan-to-lan routing, which most SOHO devices like the linksys are not designed to do.
Now to answer your question, which is the equivalent of whether it's better to put aviation fuel or diesel fuel into the fuel tank of your gasoline-engine car, put the PIX closer to the cable modem and hang the linksys off of it.
My cable modem has a different ip address than my linksys router. Do I set my outside pix interface to match my cable modem's ip address and my inside pix 501 interface to match my linksys public ip address or linksys private ip address. I am ultimately trying to set up a VPN with cisco client vpn software. Thanks Rob_dev for the last answer. I appreciated.
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending
Question Unanswered
How Can IT Teams Detect Hardware Bottlenecks in Business Networks?
0 helpful
0 replies
Question Locked
Using multi-NIC setup for NAS + router — better than VLAN?
0 helpful
4 replies
0 helpful
5 replies
Question Locked
Unknown device connected to my network
0 helpful
2 replies
Question Locked
How to change public IP without ISP?
0 helpful
2 replies