Question Locked

PIX 501 Subnet Change and DMZs

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a pair of Cisco 501's. Both on the same subnet (obvisouly not physically) - 192.168.2.x

I now want to create a DMZ with one of the PIX's so I need to change the outside interface to something like 192.168.3.x and leave the other PIX at 192.168.2.x

The 'new' 192.168.3.x will not allow me to change the outside interface due to the disable DHCP server configuration.

What am I doing wrong? Or should I just keep the outside interface DHCP and let a DHCP server give it a 192.168.3.x lease?

Or is there some step by step somewhere on setting up nested firewalls that I need to read up on?

3 replies

by kramer9

Meant to say the outside interface s/b 192.168.2.x and the inside s/b 192.168.3.x

But same problem, just typed it wrong.

by cg it

if your other PIX can provide it with an IP address on the subnet you want, then leave it dynamic.

The perimeter PIX LAN interface should be on the same subnet of the inside PIX WAN interface anyway so you configure the PIX WAN to obtain an address, and DNS servers via DHCP. Specify the default gateway and the perimeter PIX LAN address.

Nothing really different here in creating a DMZ than with any other router [excpet you do it via CLI or SDM].

This discussion is closed to new replies.