Question Locked

Port Forwarding

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I bought MyXerver NAS hard drive and wanted to access globally through ftp.

I have buffalo wirelless router and dont know what port no to be put in TCP/UDP.

My wirelless router ip is 192.168.11.1 and nas ip is 192.168.11.2.

I have enabled ftp port 21 in Myxerver NAS.

Can anyone tell me how to setup port forwarding so that i can access my files anywhere.

8 replies

by Former member

Clarifications

by wizard-09

Don't post IP addresses on the internet, even if it may be a private addresses.

You need to log onto your wireless routher and open port 21 for FTP, you then need to install a FTP server on your Computer were the NAS is attached, you then need to configure the FTP server then download a FTP program to connect to the FTP server.

http://filezilla-project.org/

Try the link above for your needs.

Keep us informed as to your progress if you require further assistance.

If you think that any of the posts that have been made by all TR Members, have solved or contributed to solving the problem, please Mark them as Helpful so that others may benefit from the outcome.

by Former member

I will try and reply to you

thanks

by Former member

Hi
Thanks for replying me.

well at last i configure access nas through ftp but not installed any software to connect it

I just wanted to share some stuff with you guys.

What I did is given the ip no of nas in router Port Forwarding (TCP/UDP-21)and made a user id in nas given rights r+ with password.

If you try with your isp ip in our own network it wont work.

Tried in my friends house with ftp://MyIPaddress it worked and asked for user name and passwords.

Someone advised me to configure dmz which is not secure at all it will show to the whole world.

by wizard-09

You try accessing it on your own machine with the ip 127.0.0.1 ;)lol

by nyinyilwin.sg

Hi,

In order to see your MyXerver device from outside, you must configure two things;

1> Register one of the Dynamic DNS websites and declare your router's IP there. (eg. www.dyndns.com)

Create your host name and assign the IP (your router IP)

2>

a. Your router--> Port Forwarding

In advanced setting-->Virtual Server or advanced setting-->Port forwarding
For using FTP, you can use TCP (Protocol) as port number 20-21

For using web administration, you need to declare TCP/UDP (Both) as port number 80 to use HTTP service.

In some router, you may require to declare your MyXerver device as DMZ Server(Advanced Setting / DMZ )

b. Your router--> WAN Setting (Wold wide web)-->Dynamic DNS

Dynamic DNS -->Enable
DDNS Provider --> Use one of the sites www.DynDNS.org(Dynamic), or www.No-IP.com, or www.TZO.com
Login name --> Fill your registered name
Login password --> Fill your registered password
Domain name --> Fill your registered domain name

Then, the configuration is completed and you can start access your MyXerver device from anywhere using one of the

FTP client programs.
You can also use the web configuration console anywhere using http://(your registered Dyndns website name)

I believe that my explaination may help you to configure your MyXerver device. If you need any assistance from my side, feel free to contact to my mail nyinyilwin.sg@gmail.com

Best wishes,

Nyi Nyi Lwin

by Former member

I tried public ip no not the one which you have mentioned.

by wizard-09

The ip i give you for your own PC you should be able to access it if you have filezilla installed on the machine in question as a ftp server, try it and see how it goes ;)

This discussion is closed to new replies.