Question Locked

Power off when HDD is connected.

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

My desktop failed to boot today so I started to investigate.
I found out that the computer runs fine when the HDD is not connected to the PSU.
CD/floppy/motherboard/fans all work fine.
When HDD is connected, upon power up, whole device turns off after 1-2 seconds of activity.
I tried all three voltage setting on the PSU, all failed to sustain support.
Thank you for your help in advance.

4 replies

by older mycroft

Except - without the HDD the computer can't boot.

[i]"I tried all three voltage setting on the PSU, all failed to sustain support."[/i]

[b]...What does that tell you ?[/b]

[i]Maybe your PSU is knackered ?[/i] ;)

by lhong1987

i meant, the bios starts the normal booting sequence until HDD check :)

i thought the PSU was goner too.
However while I was working on it, somehow it worked once.
then after turning it off and on, it failed to start again. which was odd.
I guess i need a new PSU :p

by mjd420nova

It does sound like the hard drive has failed. There are few things you can try to recover any data on it before attaching a rope and using it as a boat anchor. Holding the unit in your hand, use a twisting motion as if you are trying to rotate the platters. This may free up the motor that drives the platters and allow it to start and spin, letting you boot and recover any data. The other fault maybe with a voltage regulator on the control board of the drive. This could be replaced or even removed and bridged long enough to get the data off. A total replacement of the control board by one from an exact replacement would return it to operation and allow data recovery. Sometimes a cooling cycle in a refrigerator would allow operation and sometimes a heating cycle in an oven set to very low (125 degrees) would allow operation long enough to recover the data. Otherwise junk it and start over.

This discussion is closed to new replies.