Question Locked

power on light starts blinking rapidly when you plug the computer into ac

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have an emachine on the bench that starts up on it's own when you plug it in to AC power. It does not POST. The power on lite in front of the case just starts blinking rapidly and there is a clunking noise starts at the same time. When I opened the case I found it was very dusty inside, to the point you could not see the cooling fins below the CPU fan and the power supply was also full of dust. The machine is six years old and has never been clean according to the customer.

I am thinking the problem is the whole system is suffering from an overheating problem and not worth fixing this $400 machine.

What do you all think?

Thank you Joe

3 replies

by edward_cox

If you are hearing a clunking sound, then it sounds to me as if the Hard-drive is gone. Try unplugging the hard-drive from the power-supply. That should eliminate one of the problems. If it post, then the PC just needs a new HD. As for the cost of repair, and cleaning plus a new HD and reloading the system. I agree that it may not be worth the time and effort. 6 years old, I do not think so. It depends on the customer.

by liljoe690

Thank you for your post. I should have put in mine it was not the hard drive making the noise. I had put my fingers on all the compontents to see if I could feel where the sound was coming from. It felt like the CD-rom, but when I unplugged it the sound did not stop. Never did figure it out. I found the power supply to be cutting off after a time. I think it was cutting power to all systems for a long time, because the customer said sometime the cd-rom would not open and then would work fine later. The hard drive did act up when I put it in an external drive housing to recover data. I think the whole system was feeling its age. Thank you again for your help

This discussion is closed to new replies.