Question Locked

Power problem

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I shut of my system when I left for 2 days. I came back and it would not power up. I have an LED light that is on when the PC is off, which is on but very faint, so I dont think its the power supply because it appears to have power. I was told it might be the motherboard battery. Any thoughts?

Specs:

OS: Vista
Board: TYAN Thunder K8WE - S2895
Power: Turbo-cool 850 ETX-PFC
CPUs: 2x AMD Duel-core 2.2
GPUs: nVidia 6800 ultra's w/ SLI
Cooling: water-cool w/ 9 silenX fans

6 replies

by mjd420nova

Do the fans turn?? if the fans turn okay, then I would suspect the CMOS battery for the BIOS is dead. Weak or dead CMOS batteries can cause some really strange problems.

by ryanodon

I don't hear anything at all, which is leading me to believe that its the power supply.

by ghostbrowser

The led may be lit by the standby 5v power supply it is possible for that to still work
But the main 5v 3.3 etc is fried
the main power to the mother board is turned on buy a signal from part of the chipset which runs on the standby 5v

So the problem is you dont know if its the mother board or the power supply

But the power supply is the most simple to replace

by sgt_shultz

i would start at the beginning with this. like, don't assume your power strip is still good, faint led notwithstanding. i would start with a known good outlet. then i would start pulling parts off, starting with external peripherals. then i'd open the box and see if anything looked like it were getting power. maybe reseat some cards, especially if you have ram or if this is a workstation with odd modules...then i'd pull the power off hard drive and other internal stuff to see if system will come up.

by langlier

Rather then replace the Power Supply I'd recommend 2 things to have handy as they can be a PC enthusiasts best friend. A Power supply tester (make sure to get a 24 pin tester) and a multimeter. PS Testers are cheap (10 - 15 bucks) and are helpful. Multimeters can vary depending on quality but if you are working with PCs/electricity I recommend having access to one.

In this case the PS tester will tell you if the PS is good or not (note: the -5 test may fail on a lot of newer power supplys. this is not a bad power supply but rather just an unused line in newer boards/supplys). From there Strip your system to its bare necessities - RAM, Proc, and video card. See if you get any boot up. Reseat the RAM and proc if you still fail. after reseating if you are still failing youve either got a bad proc or bad MB.

This discussion is closed to new replies.