Question Locked

PowerEdge 600SC IDE drive won't boot

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I recently came across a Dell PowerEdge 600SC with a RAID 1 array (two 150 GB drives) that has two partitions on it. C: and D:
The two drives in the array are around five to six years old and need to be replaced for migration to a new server in the near future. I have cloned off the partitions C: and D: to individual IDE drives (Western Digital drives). I put C: on an 80 GB and D: on a 500 GB. The DELL BIOS ver. A06 sees both drives and you can access the data from drive D: no problem.
My problem comes when I try to boot from the new drive C: (80 GB) the BIOS just hangs with a flashing cursor no boot. I am using Dell part# 5P434 - 40P Internal IDE cable and set the drive to cable select on the primary IDE no boot- I also tried setting the drive to Master still no boot.
Has anyone come across this? Is it the BIOS or did the partition not clone correctly?

4 replies

by peconet tietokoneet

Make sure that the IDE in question is connected correctly and on the IDE port of the motherboard, not the SCSI IDE port.

by web

The board only has IDE ports, the BIOS sees the hard drive on the primary 0 but will not boot...

This discussion is closed to new replies.