You will need to check the Bios Power settings and look for settings like this and make sure that it is enabled.
S3 Suspend to RAM (Sleep)
Common BIOS entry Keys
F1
F2
DEL
ESC
F10
You will know when to press this key when you see a message similar to the below example as the computer is booting. Some older computers may also display a flashing block to indicate when to press the F1 or F2 keys. Some newer computers may not display it at all so see the tip below.
Press to enter BIOS setup
Tip: Hold a Key down, this will cause a stuck key error, which may allow you to enter the BIOS setup remember to save the settings if you have made any changes.
Log on to the computer as an administrator.
Check the Event Logs for errors and the Event ID which can be used to track down the problem. The Error is in the right hand pane. To get the information double click on the Error and when it opens click on the Icon that is under the Up/Down arrows and it will be copied to the Clipboard and can be pasted into Notepad.
Click Start and right click on My Computer and click Manage
Click on the + sign next to Event Viewer to expand it.
Left click on Application to highlight it.
Left click on System to highlight it.
Here is an Example
Event Type: Error
Event Source: MsiInstaller
Event Category: None
Event ID: 10005
Date: 1/06/2008
Time: 7:56:52 AM
User: AMBO\Rob
Computer: AMBO
Description:
Product: Microsoft Network Monitor 3.1 -- The installer was unable to configure automatic updates. Visit http://update.microsoft.com to get updates for Microsoft Network Monitor and other Microsoft products.
For more information, see Help and Support Center at http://go.microsoft.com/fwlink/events.asp.
Data:
0000: 7b 42 44 46 38 32 30 46 {BDF820F
0008: 33 2d 37 39 41 36 2d 34 3-79A6-4
0010: 41 43 46 2d 42 39 31 30 ACF-B910
0018: 2d 34 33 42 32 36 42 42 -43B26BB
0020: 38 39 34 43 43 7d 894CC}
Have you updated all of your Device Drivers especially the Video and Chipset.
Have you recently installed new software or hardware that may have caused the problem.
I would try sfc /scannow and see if that fixes it.
http://support.microsoft.com/kb/310747
How to perform an in-place upgrade, or reinstallation of XP.
http://support.microsoft.com/kb/315341
1: Right click My Computer, select properties
2: Click the Hardware Tab and press Device Manager button
3: Expand the universal Serial Bus Controllers
4: Double click on the USB Root Hub
5: Select the Power Management Tab and check the "allow the computer to turn off the device to Save Power
If you have more than one USB Root Hub, then you should apply the steps to each one of them. That's it, Reboot
As you can see there are a couple of options available before you have to reinsall. Other peers may know of something else to try but I am hoping that it will be picked up in the event logs.
Keep us informed as to your progress if you require further assistance.
If you think that any of the posts that have been made by all TR Members, have solved or contributed to solving the problem, please Mark them as Helpful so that others may benefit from the outcome. ;) :D