3 replies
by lycanz Accepted solution
by oh smeg Accepted solution
As either a Slave or on the Second IDE Channel.
If you have it set to CS Cable Select and it is on the Primary IDE Lead it should be in the middle but even that may allow it to become the Boot Drive. Ideally you should set it as Slave and place it on the second IDE Channel but even if you must place it on the primary IDE Lead you need it set to Slave and connected to the Middle Connector on the IDE Lead.
Col
by rob miners Accepted solution
that you are booting from the Secondary drive?
Set the Jumper settings on your Primary drive as Master and connect it to the end of the IDE cable that is connected
to IDE1.
Set the Jumper settings on your Secondary drive as Slave and connect it to the middle of the IDE cable that is
connected to IDE2.
When you have your Jumper settings and the drives connected properly try this.
Boot from your XP CD and press the first R to enter the Recovery Console.
At the recovery command prompt type in these commands pressing the Enter key after each one.
diskpart
select disk 1
select partition 1
inactive
select disk 0
select partition 1
active
Now type
EXIT to exit the diskpart session
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending