Question Locked

Print server won't work with Vista laptop

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a home network setup with an XP pc and a Vista laptop. I have a US Robotics 5461 router/print server. When my laptop had XP I could add the printer and could print. When I updated to Vista it lets me add the printer but won't print. I added it as a network printer http://192.168.2.1:1631/printers/My_Printer
adding a generic HP990c printer with Vista drivers. I have an HP2410 All in One but was told to add it as a 990c in XP. I did that with vista and also tried adding the printer as a 2410 but neither one works. US Robotics website says that the router does not work by operating systems so it doesn't matter which O/S I have. Also tried adding it as a local printer instead of a network printer which was suggested on a forum. That didn't work either. Any suggestions. Thanks, Lori

5 replies

by w2ktechman

First, I know little of Vista, but Belkin is right, an IP based print server does not have any OS specific drivers. However, the printer does.
Try uninstalling the printer
reboot
re-install the printer. (with the correct driver).
Does it work?
If no, do a test page from the printer itself. What IP address is listed? It may have changed from the previous.
Try pinging the IP address. (start -- run -- cmd , then in the DOS window type "ping %ip address%" (without quotes) and press enter.
If it replies back properly, try setting it up as a local printer and create an IP port for it. Test again.

If it still doesnt work, then open up the properties of the printer. Is there anything that may need to be reconfigured?

by p.j.hutchison

You can preinstall the driver by doing the following:
1. Open Printer and Faxes, Control Panel
2. Select File, Server Properties, Printers
3. Click Add and add the driver you downloaded
4. Close Server Properties
5. Now try to connect to printer on your print server. Hopefully it will use your preinstalled driver.

by squirrelking

I was having your exact same problem and I found this solution on some small wi-fi forum so now I'm posting everywhere that I can.

- On Vista PC go to "Control Panel" - "Printers" - "Add printer".
- Believe or not, click "Add a local printer" (I know you want to add a network printer but that way it doesn't work).
- Click "Create a new port" - "Local Port" - "Next"
- In the next box you have to enter a port name like this:
\\PC name\Printer name
where "PC name" is the network name of the XP PC or Network Share where you have the printer and "Printer name" is the network name of that printer. Be careful with this names. Check in your XP PC "Control Panel" - "Printers and faxes" - "your printer" - right click - "share" - "share resources name"
- Choose the manufacturer and printer model of the printer you are adding.
- Now the printer will be added and you can print a test page or print something to test it.

Hope it helps until MS fixes it!

by sidskeg

squirrelking
Absolutely fantastic. You saved me pulling what little hair I have left, from my head.
Many thanks for your post.
Sid

This discussion is closed to new replies.