Discussion Locked

Problem in ICS

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

IN ADVANCED W2K I CONFIGURE NETWORK AND DIAL-UP CONNECTIONS IN SHARE DIAL-UP BY MODEM & SHARE IT BY DEMAND.
BUT WHEN EVERY CLIENT START IE5.5 THEY CAN CONNECT TO INTERNET BY SERVER.
EACH CLIENT CAN BROWSE IN INTERNET WHEN SERVER MANUALY CONNECT TOINTERNET .
WHEN CLIENTS ARE GOING TO CONNECT TO INTERNET DEMAND DIAL NOT WORK AUTOMATICALY.
I INSTALL SERVICE PACK 1 & 2 FOR W2K.
MY MODEM IS U.S ROBOTICS 56K MESSAGE EXTERNAL.
MY PHONE LINE IS PULSE MODE.
PLEASE HELP ME.

4 replies

by cul8rm8e

when you open ics on your win2k pc,open up advanced and make sure you have added the pcs you wish this server to assist in demand dialing, under (settings) you need to add these by name and configure the port to be used (80) and to use the server asdial server being win2k pc!s name,. i hope this is of some help to you,if you still have problems get back to me.

by cul8rm8e

make sure all your pc`s tcp/ip settings are configured to be assigned an ip address automatically, have you setup DHCP on your win2k server machine?

by jhoejhit

and make sure that you have chosen Demand Dial located below ICS activation under Dial-up Sharing menu.

I have setup a crossover network in appartment, My win2k is acting as my ICS server and the other side computer is win98. Both computer can use the internet. When you browse at win98 computer, my win2K computer will automatically dialing. I hate this thing up and I have disabled on demand dial on my win2k computer that can be done at dialup sharing properties.

To do this, right click onyou dial-up connection, click on sharing menu and below activate ICS there you will see On Demand dialing...check it to activate.

by awaretech

I have a crossover network with a Win98 client and a WinXP server that worked beautifully using a dialup modem connection. However after adding a DSL external modem by Bell when I reconfigure to use it everything looks good but the client cannot getemail through Outlook Express (it sees the mail but times out and can't access it).
Also the client can only reach CERTAIN web sites?? Go figure. The client is setup to get IP address automatically and the server is running DHCP I think. Would adding a hub and rewiring be necessary? Any help would be appreciated.

This discussion is closed to new replies.