2 replies
by aceman040 Accepted solution
by churdoo Accepted solution
So are we to assume that the device that you're calling your firewall at 10.10.10.254 some SOHO router/firewall appliance? And your networks are 24-bit, i.e. mask 255.255.255.0? Do you really want your wireless clients "behind" the second router such that they're segregated from the first network by NAT, I think probably not if you want them to access device(s) on the first network and presumably vice-versa.
So I guess let's start by getting your wireless devices internet access.
In your first scenario, wanting to set up the wireless network 10.10.11.0/24, The WAN interface of your Wireless router needs to be on the 10.10.10.0/24 network, and should be connected to either the switch or the first router (assuming the switch is uplinked to the first router). I would statically assign the WAN interface of the wireless router, and use for example 10.10.10.253 and the default gateway for that interface is 10.10.10.254. The LAN interface of the Wireless router can be 10.10.11.1 and can have DHCP enabled. Assuming your wired clients on the 10.10.10.0/24 network get internet access (i.e. your first network and router are set up properly), then your wireless clients should at least now have internet connectivity.
The above should work and pretty much should have worked out of the box. Suggest possibly doing a factory reset on the wireless appliance and start again. If not, post back models and perhaps we can help more.
Relative to getting LAN access for your wireless clients, there are potentially two things in the way.
1. a lot of wireless/router appliances have a default "isolation" mode for security where the wireless clients are permitted to only have internet access. You may have to find this setting on your wireless/router appliance and disable it
2. the default NAT mode of the wireless/router appliance will disallow things on the 10.10.10.0/24 network from accessing your wireless clients. If you do indeed want the wireless clients in a separate network, then consider what kind of access your first LAN will need of the wireless clients, and you may consider turning the wireless/router appliance into its "router" mode versus "gateway" mode. Router mode will disable NAT and the appliance will act more like a router.
Hope this helps
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending