Question Locked

Problems with monitor

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

When I turn on my computer, the bios screen shows up, the windows loading screen shows up but when windows finally loads..the monitor has all these horizontal lines in it like its broken and you can't read anything, but I know it isnt broken because it just showed working screens.

Any suggestions would be greatly appreciated.

Thanks :)

4 replies

by oh smeg

As the Refresh Rates or Screen Resolution are set too high for the current monitor.

You may be able to get around this by booting into [b]Safe Mode[/b] and altering the Video Drivers Refresh Rates and Resolution but I don't think that this will be an option as the Video Driver isn't loaded in Safe Mode.

You need a monitor that is capable of displaying the screen resolutions or refresh rates that the Video Card is set to so that you can alter the current settings back to something that the monitor that is connected can handle.

Col

by dmambo

Use the shotgun approach. Boot to safe mode (F8 if you're using W2000 or XP) and open the device manager. Uninstall all the monitors shown and then reboot normally. Windows will install new monitor(s) and you'll be able to change the display settings as you see fit. I think Col was right when he pointed to the refresh rate.

This discussion is closed to new replies.