Question Locked

Problems With Remote Desktop, and Entering Country Location

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am using XP Pro with the third service pack. I have had two problems since I have put XP on a new hard drive in this computer a couple of months ago.

The first problem is entering the country in the drop-down window in the area, where you set up a modem. When I go to enter the country, that area is blank and it won?t let me put in the area code either. I thought there might be a problem with the modem, since it was an older one so I bought a new one, and the same thing happens.
For some reason the modem does work with fax software, but when I try to use application like Outlook?s phone dialer, it says I need to set up the modem, which of course I can?t.

Another problem I am having is with remote desktop. I have used remote desktop ever since I started using XP Pro. I made sure all of my firewalls settings are correct as far as I know. I have a couple of other computers with XP Pro on them that I can access remotely, and they work fine with the same firewall settings. What happens is that when I am at a remote computer, whether I?m in another town or even in my office on the same network it will not connect. I use static IP addresses in my office. When I enter in the address of the remote computer, and hit connect, within a split second it just shuts the connection down. One thing I did try in the office was to remove the LAN cable from the computer I want to connect to. After disconnecting the cable and going back to a remote computer I typed in the IP address again, and this time it took a while for the connection to time out. I assume there is something definitely configured wrong in the host computer, but I don?t know what.

Thank you in advance for all your help.
Larry B.

4 replies

by pshiflet-24

Since the disconnection takes longer with the cable unplugged, the issue is at the computer you are trying to connect to. It is rejecting the connection immediately when it is connected. You mentioned that you configured the firewall. Did you check the "Allow users to connect remotely to this computer" check box in the Remote tab of the System Properties window?

Please let me know if this is helpful or you have further questions. Thanks.

by larryb

I have just about done everything I can think of with this problem. I have worked with computers for quite a while, and have installed XP professional on probably about 20 computers. This is the first time this has ever happened and is very frustrating. The first thing I check is the allow users to connect remotely to this computer check box in the systems property window.I have some other things that are acting goofy on this machine also, so if worse comes to worse, I will have to reformat the disk over and reinstall XP on it again. That's a lot of work, but I guess if there is no other way that will be it. Thank you for your reply.
Larry B.

by seanferd

The target computer, to which you are trying to connect, has RDP on, and configured to allow incoming connections?

Just wasn't sure from reading your post.

There are still complaints about SP3, FYI.

This discussion is closed to new replies.