Discussion Locked

PSU mainboard fails to boot

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I'm in the process of rebuilding a computer. Got the hitech redundant power supply. It was all working fine when I tested it with an old ATX power supply now it fails to even show the bios start screen.

There are no beeps from the mainboard. Drives spin, the built in LED on the onboard network card lights up.

The only think I can detect is that the PSU is just a tad high in voltage when it's not under load. Say 3.4x V | 5.4 V

I've checked all the logical stuff... no screw under the board, pulled the ram and drives out... nothing.

So the question is... is voltage being a we bit high (when not under load) likely to cause this to occur?

Yani

3 replies

by akayani1

I don't think this is a power issue I thing I 'might' (not will to admit my ID 10 T error) have plugged the power supply in wrong way round. (GAWD that's grovelling on the floor for you, when you should get a table)

So now my question is have I
1. Blown the MB
2. Blown the CPU
3. Blown the Bios

Got any clues on how to qualify which without a pile of extra parts?

The lack of any beeps give me a gut feeling that the bios is shot.

Yani

by mjd420nova

If you have a meter to read resistance, check the power supply inputs for shorts and try to track it down. Most often when reverse polarity power is connected, one or maybe more capacitors will short and then cause the power supply to cut out. You might have heard a pop when power was applied the first time when reversed, if so a close inspection would reveal the culprit.

by deepsand

Try the "Questions" forum; the "Discussion" forum is for matters of general discussion, not specific problems in search of a solution.

Post problems such as this to the "Question" forum, rather than the "Discussion" forum. There are those who specifically seek out problems in need of a solution, and that's where they go to look for such.

Additionally there are the benefits that:

1) The "Questions" forum provides for your feedback, by way of your being able to mark "helpful" responses as such. This does not necessarily mean that a given response contained the complete solution to your problem, but only that it served to guide you toward it. This is intended to serve as an aid to those who may in the future have a problem similar to yours, so that they might have a ready source of reference available, thereby perhaps obviating the need for them to repeat questions previously asked and answered.

2) The revised TR makes it quite difficult to find both "Discussions" and "Questions" that have not had a fairly recent post, owing to some functions comingling them in the listings. By keeping each type in their respective forums, it is easier for all to find what they are looking for.

This discussion is closed to new replies.