Discussion Locked

ram upgrades and WinXP-Home

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I'd like to upgrade my RAM...i'm running WinXP,Home Edition...can i do this without messing anything up,and if so,how?

7 replies

by timwalsh

Upgrading RAM really has nothing to do with any software you are running on your computer, nor will it have any effect on the the software installed. You merely need to pick the type of RAM (form-factor and speed) that is compatible with your motherboard. Best place to check ans see what your motherboard uses is the manual that came with it. The next best place is the motherboard manufacturer's website.

by thechas

I understand your concern.
The amount of RAM is one of the items that XP checks for system configuration.

As long as you have not changed other hardware recently, a RAM upgrade should NOT trigger a product activation event.

Reducing the amount of installed RAM is more apt to trigger an activation event.

As Tim said, check what RAM is supported by your motherboard.

If you want to play it safe, use the memory configuration tools at one of the major memory manufactures web sites:
www.crucial.com
www.kingston.com
www.pny.com

For XP, I recommend installing as much RAM as the motherboard will hold / your budget allows.

When you get your RAM, it is best practice to unplug the power cord, and wear an ESD ground strap while installing RAM.

Have a can of compressed air handy to blow any dust out of the RAM slots before inserting the RAM modules.

For most motherboards, it is best to install the largest RAM module in the first slot.

You may need to enter BIOS setup when you first boot up after adding RAM to confirm the new amount of RAM.

If your system uses SDRAM DIMMs, be cautious when buying the cheapest RAM out there.
Many older boards do not support the latest 'quad' density DIMMs.

Chas

by opatzg9

The last two guys gave some great advice, the only thing I can add is some motherboards will take two different kinds of ram both ddr and sdram, so check out your motherboard to be sure that 1) if its using sdram and you wish to stay with that, how many open slots are available or are you going to throw the old away. 2) the two do not run simultaneously so one or the other would be the only option. 3) generally ram is best installed in matching pairs cause some ram just does not play well withothers. 4) watch the motherboards max ram allowed and divide the ram by the slots to determine max ram size useable.
And by all means more is better with XP or NT. Good Luck

This discussion is closed to new replies.