12 replies
by jmarmer Accepted solution
by Former member Accepted solution
If you are running XP do this:
1) Go into your bios and find out if your drive is located in the boot section.
2) Put in your Windows disk and then select "R" (repair) and follow the on screen instructions.
.................................
If you are running Vista do this:
1) Same as above in section (1).
2) Load on Vista and when you see the "install" sign look down bottom left of your screen and you will see "repair" option click on this. Now in Vista you will lose only new programs that you have installed that day (unless it is included in the restore function). You can do a restore or "repair and re-start". Do the "repair and re-start" option first. If you are still having trouble then do the same as above but select the "restore" option. (if possible).
Please post back if you have any more problems or questions.
by jmarmer Accepted solution
by jmarmer Accepted solution
by older mycroft Accepted solution
Just how many of the listed entries did you uncheck?
Also, how many of the boxes were checked in CCleaner?
by Former member Accepted solution
Boot up your computer and look down to the bottom left of your screen. You should see something like "F1, F2, DEL" key for bios, once you have noticed the key then press it (if you have missed it then press the small button on your computer, this will soft boot your computer). Press the key relating to your computer. Then have a look for your hdd in Either the the boot or hdd section (depending on your motherboard). If your motherboard is not located in the bios the your hdd has gone to the dogs (dead). Solution: buy another one. Or check that the cable is connected correctly to the motherboard and hdd.
Please post back if you have any more problems or questions.
by jmarmer Accepted solution
I unchecked many items in autoruns and then rebooted just to see if there was any difference and then the booting process went into this loop.
I did not run CCleaner.
by jmarmer Accepted solution
by Former member Accepted solution
Get a new hdd drive and a hdd powered usb case/caddy. Put the new drive into your computer and the old hdd into the usb case/caddy. Load on your Windows Xp disk (on to new hdd) and then the motherboard drivers, after this do all of the updates and then you will be able to access your files and apps from the old drive.
Please post back if you have any more problems or questions.
by jmarmer Accepted solution
by older mycroft Accepted solution
You've removed a few too many.
Did you enable the option to 'Hide Microsoft Entries' before you embarked on this killing spree?
Unfortunately unless you follow the route suggested by Peconet, you'll destroy all your existing data if you reinstall onto the present hard drive.
by jmarmer Accepted solution
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending