Networks

Ask something
Discussion Locked

Remote access to a Netware 6 FS

0 helpful
5 replies

by jf555 1 view

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello, I have a Netware 6 w/latest SVC Packs and running fine. I have implemented what I beleieve was the required SW to access it via the Internet, same set of Sw as in NW5, however, I can't get to it, IT IS NOT an IP or connection problem, it seems that not all required Sw may be runnign on the Server, Any guidelines as to what the SW should be for remote access to a NW6 server?

Thanks

5 replies

by pierrejamme

Not an answer, but a viewpoint. I hate acronyms. People read these postings and learn from them. I am certain that someone out there knows what a SW is but I am a CNE 5 and have no clue what you are asking for. I can guess that a SVC packs meansservice packs. Give us dummies some help and spell things out thank you.

by mmcdermot

There are some TIDS out there on this. My guess is that you changed the IP address on your server after you upgraded to Netware 6?

I'm assuming you upgraded this server from NW6

Anyway, there are about 8-12 configuration files you might need to change. You have to make sure all the ports are correct.

P.S. TID is short for Technical Information Document.... If you are a CNE and don't know what a TID is, then you are a paper CNE.

This discussion is closed to new replies.