Discussion Locked

Remote connect from home to office

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

My wife would like to access her office computer from home.

At the office, have DSL through Netgear M814 wireless router to two XP computers -- hers via Cat5 wire, the other via Netgear USB Wireless adapter.

At home, have cable through Microsoft Broadband Networking Wireless Base Station Model MN-500 to three XP computers -- all via Cat5 wire.

Connected today to office router and attempted to change remote management settings to allow range of IPs to access, but after putting in IP and telling router to apply access was lost -- received "Page Not Found" message after timeout.

Would like to complete router setup and connection procedures. Need help.

Thanks in advance.

3 replies

by rogmj007

It sounds as if you placed the incorrect IP addresses in the router.

What range of IP addresses did you place in the remote router? The internal LAN IP addresses or the external (Internet) IP address.

by w2ktechman

The IP address for the computers are probably non-routable IP's. You will need to look through the router documentation to set it up to route with non routable IP addresses

Also, it may be that there is a firewall setup. Look in XP and turn off the firewall.

by cham

The range of IP's were external to the router, the IP's from the home computers via the home router.

This discussion is closed to new replies.