Question Locked

Remote Desktop connection need help

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

hello everyone,

I have a problem with my remote desktop connection. I try to access my server using remote desktop but an error message says:
1. Remote connection might not be enable in the at the remote computer(server).
2. The maximum number of connection has exceeded at the remote computer (server)
3. A network error occured while establishing the connection.

I have checked the setting for the server and the remote tab is enabled, also there is no other remote users currently connected to the server as everyone else receive the same error message.
I try to ping the server but I cannot receive responses. The server that I was trying to connected is connected to a router and a firewall.

Thank you.

7 replies

by retro77

Before you jump all the way up the OSI stack to remote desktop, get your routing working. You might have a firewall issue there blocking your remote desktop and pings.

by ferdie

Hi Retro,

Thanks for the reply, I dont think its the firewall issue or router issue because I can remotely access my other server.

by retro77

But you can't ping the server? Can you ping other servers on that segment? Are you running a firewall on the server?

by alfa11

Open the task manager and look inside the users snap in, check if there are users listed there. If you see connections there highlight each one and select the log off option.
This happens because when you are connected through remote desktop and you close the windows, the session doesn't terminate, it keeps running.

by kwesi

can you remote to the server from it's own desktop. if not ensure that rdp is enabled
can you ping the server from the client.
if yes. can you then telnet to the same address on port 3389 (default rdp port).
if either of these fail then you're looking at some type of firewall blocking your connection.

by csheppard

And turned off my firewall temporarily on my server to verify if that was the problem and it was.

Also, make sure on your server, click the Remote tab, check the box that says "Allow remote connections" and then select a user to be able to use remote connections.

Also, in Terminal Services Configuration, right click the connection to the right, go to properties and set the permission for that user.

Hope that helps.

This discussion is closed to new replies.