Question Locked

Remote Desktop with D-Link DES-1108 ethernet switch

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am trying to access my work computer from home. Both machines are XP with all remote desktop setting enabled, firewall exceptions allowed etc... Home goes through Linksys wrt160n router and work has a D-link des-1108 ethernet switch. I've tried connecting with both inside IP addresses and "outside" IP addresses. Do I have to forward a port? Can I forward ports with a switch? Any suggestions would be VERY MUCH appreciated!!

3 replies

by robo_dev

I would expect that your 'work' network has a firewall of some sort?

If so, then there would need to be a port opened on that firewall as well as a forwarding rule to your PC, and possibly a static route to your PC, depending on the LAN topology.

You cannot forward ports with an ethernet switch, as these are typically layer 2 devices. And forwarding ports would not get done in your Ethernet switch anyway, it would get done in the router at the edge of the network.

Are you using a VPN solution of any sort? Enabling a remote desktop connection to a LAN connected PC is very very risky from a security standpoint.

With respect to your home router, you would need to forward the ports that are needed for remote desktop to the internal IP address of the PC. Again, this too is really risky from a security standpoint....

by larry

THANK YOU for the reply!!

So then VPN is the best alternative? Same setup issues?

Larry

This discussion is closed to new replies.