Question Locked

Replaced system board battery, now Windows fails

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Following a 12-hour power outage, my Dell XPS Windows XP PC reported that the onboard battery had failed and that the BIOS needed to be reconfigured. I opened the box, replaced the system board battery with an identical one, reconfigured the BIOS, but now I can't get Windows to start.

Windows gets only as far as displaying the "Loading Windows" screen then I briefly see a classic blue screen of death with what appears to be a GPF error, and then the PC reboots again.

After the second boot I get a Windows command line screen that tells me that Windows didn't start properly and offers various safe mode options, however I get the same blue screen error when I try to start in safe mode.

Unfortunately I never had an opportunity to write down all the BIOS settings before the battery (allegedly) failed, but I can't figure out what setting is *maybe* keeping Windows from starting.

Any suggestions?

Thanks.

-- Walt

7 replies

by oh smeg

Open the BIOS and make sure that the Correct Date & Time are in place and then set the BIOS to use performance Defaults. Save these changes as you exit the BIOS and then try booting in Safe Mode.

Pay Attention to the Drivers being loaded and tell us which one is the last to appear before the BSOD appears. If you press the Pause Key when the BSOD appears this should stop the computer so you can read the full error message and post back with that as it will or a the very least should have an Error Message on it telling you what has happened.

Col

by techmaster

Thank you Col. I did restore the BIOS to factory defaults, and it appears to recognize and configure the SATA drives. As far as drivers, the last to load is Mup.sys, and then I get a generic, "A problem has been detected and Windows has been shut down to prevent damage to your computer...

*** STOP: 0x0000007B (0xBA4C3524, 0xC0000034, 0x00000000, 0x00000000)"

-- Walt

by oh smeg

Try restarting with Last Known Good Configuration and see if that helps.

You may be required to reinstall the Video Cards Driver though latter.

Col

by techmaster

Booting to last known good configuration results in the same BSOD.

by techmaster

In the BIOS I changed the HD autodetect from AHCI (factory default) to ATA, and now Windows appears to be working normally now.

The only anomaly is that Windows now sees my 2-year-old USB back HD as New Hardware.

I hope this is the end of it. Thank you Col for your help.

-- Walt

by oh smeg

Glad I could be of some small assistance here.

Col

This discussion is closed to new replies.