Question Locked

Replacement NIC connectivity issues with Static IP assignment

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Recently I replaced a NIC card on a exchange server that went bad(on-board). (Windows 2003 std server, exchange 2003) I disabled it in the bios and put in a replacement card. When the replacement card used dhcp to get it's IP it worked fine, but after I assigned it the static IP of the mail server then all internet connectivity was lost, but internal connectivity remained. Why doesn't the new NIC access the internet with a static ip? Is their some sort of connection between mac address and the static ip somewhere that I need to change?

Thanks to any helpful suggestions.

2 replies

by jrtownsend

I had the same problem today. After removing all instances of the old NIC, resetting the Winsock and clearing the arp table, I found the answer was in the router. This router has no command line access to look at the arp table. I had repowered it with no luck, but decided to disconnect it for 30 seconds (I sound like cable/dsl provider support). I think that allowed the arp cache in the router to clear. Everything has worked fine since.

This discussion is closed to new replies.