Question Locked

Right Click

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I went on site today and went to do troubleshooting on a system, and the mouse had no right click. I'm not sure if it had been disabled in the registry or its a bad mouse.(Security reasons didn't allow me to bring another one in)
How can I find out if it has been disabled through software? I checked the properties in Control Panel-Mouse and didn't see where it could be disabled/enabled, and for any problems in the hardware via Device Manager. Thanks.

5 replies

by entawanabi

Reload the mouse Program if it still does not have the right click then it is disabled or the board is visibly damaged.

Enta Wanabi

by beachboy11

Its just a generic mouse on an eMachine (I know, I know) There is no mouse program, its just a PS2 config. Now if the PS2 was damaged, then the mouse would not work at all. Is the "Program" the mouse program??

by entawanabi

Ther actually is such a program and that you do not have it is not unusual, get a mouse program and load it; as for damage there does not have to be a tottally unworking mouse for there to be damage.

Enta Wanabi

by tg2

Security reasons? Obviously then, they don't want their pc repaired.

You either get to bring your trouble shooting tools or you don't and if you don't how do you troubleshoot?

You're wasting your time, and tell them this, if you can't bring in a mouse, or can't borrow a mouse that appears working on another machine to help diagnose. Otherwise you could be looking for hours and no one will put up with "i couldn't bring in a 5 dollar el-cheapo mouse and test" when they are faced with 5 hours (usually at 50 to 150 dollars an hour) of time wasted looking for some setting that nixed their 2 bit mouse ability.

This discussion is closed to new replies.