Discussion Locked

Routing And Remote Access - Strange Behavior, Service requires stop and sta

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi,
My system (WinXP (SP2)) lost its connection to my ADSL modem. At first, this loss was accompanied by a malfunctioning of the ipconfig instruction.
The situation is as follows:
1. My Routing and remote access service is configured for automatic start.
2. When the computer boots, it's ina started position,
3. When I type "ipconfig /all", it ends with an error.
4. When I go to my services, stop Routing and remote access service, then restart it and then try ipconfog, the instruction works as expected.
What's wrong?

Ran

p.s. This may look like a minor annoyance, but since this may be the cause for another problem, a major one, I'm looking for its solution. The major problem is that my system doesn't recognize my adsl modem, leading to inability to establish network communication.

2 replies

by bfilmfan

Unless you are using this XP system as a gateway, if you have a router or your ISP is providing DHCP service, you don't need these services running at all.

by rancherm

Hi,
You may be right, but the fact is that I can't get ipconfig run without activating this service.
Well, my main concern is different. When I run ipconfig /all, my network card (Intel PRO/1000) is not identified. In addition, all my efforts to ping my modem also fail.
So, can you make sense of this bizzare behavior. How can I revive my ADSL connection?
I've reinstalled SP2.
I've uninstalled my NIC.
I've updated the drivers for the NIC.
Nothing helped.

Ran

This discussion is closed to new replies.